Tone Generator

Generate a sine, triangle or band-limited saw/square test tone with precise frequency and duration.

About this tool

Tone Generator creates a test tone at an exact frequency and length, using a sine, triangle, square or saw waveform. It is handy for checking speakers and headphones, finding resonances in a room, tuning an instrument, calibrating levels or feeding a test signal into a plugin chain.

How to use

Set frequency, duration, waveform and level. Generate audio, start at a low listening volume and export WAV.

  1. Set the Frequency in Hz, anywhere from 20 to 20,000 Hz, and the Duration from 0.1 to 30 seconds.
  2. Set the Peak level in dBFS, between -48 and -3. The default is -18 dBFS.
  3. Pick a Waveform: Sine, Triangle, Square or Saw.
  4. Press Generate audio, turn your monitoring down and press Result to listen. Press Stop to end playback.
  5. Press Download output to save the tone as a 24-bit mono WAV.

Production tips

  • Start at a low volume. Continuous tones sound louder than music at the same peak level, and high frequencies can be tiring.
  • Use 440 Hz (A4) as a tuning reference, or 1000 Hz at -18 dBFS as a general-purpose calibration tone.
  • Sine is the cleanest tone and has no overtones. Square and saw add harmonics, which makes them better for hearing how a filter or distortion plugin behaves.
  • Step through bass frequencies, such as 30, 40, 50 and 60 Hz, one tone at a time in your own room to find where your speakers drop out or boom.

Know the limits

Continuous tones can sound loud. Saw and square waves use harmonic synthesis limited below Nyquist.

Frequently asked questions

Why do the saw and square waves not alias?

They are built from harmonics that are only added while they stay below half the sample rate (Nyquist), so the tone stays clean. At very high frequencies there are fewer harmonics, and the wave looks closer to a sine.

What sample rate and format does the file use?

The tone is generated at 44.1 kHz as a mono signal and exported as a 24-bit WAV. A 5 ms fade is added at the start and end to prevent clicks.

Is it safe for my speakers?

A steady tone at a high level can stress speakers and ears. Keep the monitoring volume low, avoid extremes at the lowest and highest frequencies and raise the level slowly.

Audio is processed on your device. JavaScript is needed to use the tool.