Stereo Width
Adjust the mid/side balance of stereo audio and check the resulting sample peaks.
About this tool
Stereo Width adjusts the balance between the mid (center) and side (difference) parts of a stereo file, so you can narrow it toward mono or widen it. It is for mixing and sound design work where a sample, pad or full mix feels too wide, too narrow or unstable on mono speakers.
How to use
Load stereo audio, set width from mono to expanded stereo, process and compare against the source.
- Drop a stereo audio file onto the upload area. Mono files are rejected for this tool.
- Set Width between 0 and 2. A value of 0 gives a mono result, 1 leaves the stereo image as it was and values above 1 widen it.
- Press Process audio. The tool scales the side signal and leaves the center unchanged.
- Listen to the Result and compare it with Original, and read the sample peak in the report to see whether widening raised the level.
- Press Download output to save a 24-bit WAV.
Production tips
- Moderate widening, for example 1.2 to 1.4, is safer than the maximum. Extreme settings can make a mix feel unfocused and cause mono problems.
- Always listen to the result in mono afterwards with the Mono Converter. If the lead or bass loses level, reduce the width.
- Narrowing to around 0.5 to 0.8 can tighten a busy sample or a stereo pad that fights with your vocal.
- If the output exceeds 0 dBFS after widening, lower the Width or normalize the result with the Peak Normalizer.
Know the limits
Widening can raise peaks and reduce mono compatibility. Reduce the width or normalize if the result clips.
Frequently asked questions
Does widening add real stereo information?
No. It only changes the balance between the center and the difference signals already in the file. A true mono file cannot be widened this way, and the tool needs stereo audio.
Why does the peak change?
When the side signal is boosted, left and right peaks can get higher than the original. The report shows the sample peak, and a warning appears if the output goes above 0 dBFS.
Is the center changed?
No. The mid signal, which is the sum of left and right, is kept as it is. Only the amount of side signal is scaled by the width value.
Audio is processed on your device. JavaScript is needed to use the tool.