Spectrum & Dynamics
Inspect relative frequency energy, RMS, crest factor, sample peak, DC offset and stereo correlation.
About this tool
Spectrum & Dynamics gives you a quick technical read on an audio file: sample peak, RMS, crest factor, DC offset, stereo correlation, the number of clipped samples and a chart of relative energy across the frequency range. It helps producers and engineers spot problems before mixing or mastering.
How to use
Upload audio to generate a frequency chart and measurement report. Export JSON for your production notes.
- Drop an audio file onto the upload area, or press Load example to analyze a generated loop.
- Press Process audio. Local analysis starts and the report appears below the waveform.
- Read the measurement boxes: Sample peak, RMS, Crest factor, Correlation, DC and Clipped samples.
- Study the Relative frequency spectrum chart, which shows logarithmic bands from 20 Hz to 20 kHz.
- Press Download report to save the measurements and spectrum bands as a JSON file for your production notes.
Production tips
- A crest factor (peak minus RMS) that is very small points to heavy limiting or clipping, while a large value means the material is dynamic.
- Correlation near +1 means left and right are almost identical, around 0 means wide stereo, and negative values suggest phase trouble that can hurt mono playback.
- Look for a hump in the low mids or a harsh peak in the upper mids, then confirm it by ear before cutting anything.
- Any non-zero Clipped samples count means some frames reached full scale. Listen for distortion at those spots.
Know the limits
Spectrum is relative; measurements are not calibrated SPL, integrated LUFS or oversampled true peak.
Frequently asked questions
Does this show LUFS or true peak?
No. It reports sample peak and RMS over the whole file, which are different from integrated LUFS or oversampled true peak. Use a certified meter for broadcast or streaming compliance.
How is the spectrum calculated?
It averages Hann-windowed FFT frames taken across the file into 72 logarithmic bands. The result is relative energy, not calibrated sound pressure, so use it to compare balance rather than to read absolute levels.
What does the DC value mean?
It is the average sample value. A number far from zero suggests a DC offset, which you can remove with the DC Offset Removal tool.
Audio is processed on your device. JavaScript is needed to use the tool.