Reference Desk

Compare two tracks with RMS level matching, sample peak, stereo correlation and relative spectrum.

About this tool

Reference Desk lets you compare your mix (A) with a reference track (B) under fair listening conditions. It matches RMS levels for playback, switches instantly between the two and shows peak, RMS, stereo correlation and a rough spectrum. It is made for producers and mix engineers who want to judge balance rather than loudness.

How to use

Load your mix and a reference, enable level matching and switch between them. Export the measurement report for later comparison.

  1. Drop your mix onto the A panel and a commercial or target track onto the B panel, or press Load A/B example to try a generated pair.
  2. Read the measurements under each waveform: sample peak, RMS, crest factor, left/right correlation, frames at the peak limit and DC average.
  3. Press Start comparison, or Space, and switch between A and B with the buttons or the A and B keys. The playback position is kept when you switch.
  4. Keep Match RMS levels on so that louder mastering does not fool your ear. Turn on Monitor in mono to check how both tracks fold down, and use the A start and B start fields to line up the same section.
  5. Study the spectrum overlay, then download the analysis JSON as a record of the comparison.

Production tips

  • Compare sections with similar density, such as chorus against chorus, and set the start offsets for each file so you are not comparing an intro with a drop.
  • Use short switches of a few seconds and focus on one thing at a time: low end, vocal level, brightness or stereo width.
  • If the spectrum shows your mix well above the reference in the lows, check a few bass notes on a second playback system before you cut anything.
  • Level matching is for listening only. Do not use it to decide how loud to master.

Know the limits

RMS and sample peaks are not integrated LUFS or true-peak compliance measurements.

Frequently asked questions

Is this a LUFS or true-peak meter?

No. The tool measures sample peak and RMS over the whole file, plus stereo correlation. RMS matching can be thrown off by quiet intros or very dynamic material, and these figures are not integrated LUFS or true-peak values.

Why do both tracks seem to have the same loudness?

With Match RMS levels enabled, the tool applies a gain to either A or B (or both) so their RMS is equal during playback. The gain shown in the badges is only applied to what you hear, and your files are never changed.

How does the spectrum work?

It averages 18 Hann-windowed 4096-point FFT frames across the file, with the channel power combined. It is a rough comparison curve, not a calibrated analyzer.

Audio is processed on your device. JavaScript is needed to use the tool.