808 Tuner

Find the fundamental note and cents offset of a tonal bass sample, then tune it to your project.

About this tool

808 Tuner estimates the fundamental note of a tonal bass sample and shows how far it sits from the nearest note in cents. You can then retune it to the note your track needs and export a WAV. It is made for producers who want 808s, subs and bass one-shots to follow the key of the song.

How to use

Load a monophonic 808. Analyze its stable pitch, choose a target note, listen and export a tuned WAV.

  1. Drop a single, clean 808 or bass note onto the upload area, or press Load example 808 to try a generated one.
  2. Check the detected note, frequency in Hz and cents offset on the tuner display. Press Analyze pitch again if you want to repeat the analysis.
  3. If detection fails or sounds wrong, tick Set source note manually, then choose the source note and a fine tune between -50 and +50 cents.
  4. Choose the Target note. The panel shows the pitch shift in semitones, the speed multiplier and the new length of the sample.
  5. Press Play tuned audio to listen, keep the -1 dBFS normalize option on if you want headroom, then download the tuned WAV.

Production tips

  • Find the root of your song first, for example with the Musical Key Detector, then tune every 808 to that note or to a chord tone. A bass that is a few cents off will clash with your chords.
  • Retuning works by resampling, so raising a sample shortens it and lowering it lengthens the tail. If the decay changes too much, pick a source sample closer to your target.
  • 808s with a pitch glide or a sharp click at the start can fool any detector. Confirm the result by ear against a keyboard note before exporting.
  • Very low notes are hard to hear on laptop speakers. Check the tuned sample on headphones or a spectrum view, not only by loudness.

Know the limits

Designed for a single tonal source. Retuning changes duration and playback speed; it is not independent time stretching.

Frequently asked questions

Does it work on full songs or chords?

No. The detector looks for one stable fundamental between about 25 and 800 Hz, so it is meant for single-note, mono sources. For a whole track, use the Musical Key Detector instead.

Does tuning keep the original length?

No. Pitch is changed by resampling, so playback speed and duration change with it. The panel shows the speed multiplier and the output length before you export. Tuning is limited to roughly three octaves each way.

Which octave numbering does the tool use?

Middle C is C4, which is MIDI note 60, and the tuning reference is A4 at 440 Hz. Some DAWs label the same note one octave higher or lower, so always check by ear.

Audio is processed on your device. JavaScript is needed to use the tool.